Most Active Stories
- Jim Skeffington, PawSox President & Prominent Lawyer, Has Died
- Scott MacKay Commentary: MacKay's RIC Commencement Speech
- TGIF: 18 Things to Know About Rhode Island Politics & Media
- Biologists Plan To Continue Tracking Beluga Whales In Narragansett Bay
- Elorza Says Further Steps Needed to Stabilize Providence's Finances
Rhode Island Public Radio transmits on three different signals:
- 88.1FM WELH in Providence and northern RI, and bordering MA communities.
- 91.5FM WCVY in Coventry and central RI.
- 102.7FM WRNI in Narragansett and southern RI, Block Island, Aquidneck Island, and parts of the East Bay.
In general, if you are driving on I-95, you can listen to 88.1 FM north of the split between I-95 and Route 4. South of the split, you should be best served by 102.7FM. East Bay, including parts of Bristol and Warren, and also Portsmouth, Middletown and Newport are best served by 102.7FM. 91.5 fills in gaps between 88.1 and 102.7, and reaches most of Kent County as well.
The map above shows approximately where you should be able to tune in each station. However, there are many factors that can influence quality of reception, including: quality of receiver/antenna, terrain, atmospheric conditions (heat, mostly) and the presence of other stations.
For our listeners in or near Warren, Barrington and Bristol:
If you are a customer of Full Channel cable TV, you can hear the audio of RIPR on channel 799 of your television set.
Listening in the Car:
In-car listening is most ideal as you have an external antenna and there are no walls or a roof around it to block the signal. The downside is that since you're driving around, you're in a constantly-changing reception environment. You're moving closer to, or further away from, our stations, and multi-path interference may be an issue.
When you're in the car, the biggest limitation to listening is other radio stations. There are stations broadcasting on 88.1 out of Westerly and New Bedford, and on 88.3 out of Bristol. These limit 88.1's coverage area. Similarly, there is a major station on 102.5 in Boston that limits reception of 102.7 to the north.
Most factory-stock car radios are pretty good. Aftermarket radios are a mixed bag. If you have the option, it's often a good idea to get an HD Radio-equipped radio. You can try Best Buy, or Crutchfield, among others. HD Radio receivers are usually of high quality overall for both analog and HD Radio digital, and thus may help in receiving RIPR, even though we only broadcast in analog. As always, try experimenting by switching to different RIPR signals!
Listening in the Home:
In-home listening has the advantage of a more stable reception environment, but there are other concerns that you may want to address.
Most clock radios, tabletop radios and component receivers are of poor quality. They need a lot of signal to work, and conversely have trouble filtering out unwanted signals that are too strong.
During hot days in the summer, you may experience tropospheric ducting - a temporary phenomena where very, very distant stations (e.g. from Wisconsin or Louisiana) can override local stations for a few minutes or hours.
With clock radios and similar tuners, many have a coupler inside that makes the power cord into the FM antenna. Similarly, many portable "walkman" style radios use the headphone cord as an FM antenna. Adjusting it may improve reception (see notes about a di-pole antenna below). If you're getting too much signal from other stations (e.g. you live near the broadcast towers in Johnston or East Providence) you might try balling up some of the power cord into a bundle; this makes a poorer antenna and thus reduces the undesired signals to a level where the radio can tune them out. But ultimately, these radios usually just aren't very good tuners, and unfortunately the only solution is to get a better radio (or listen on the web).
What makes for a better radio tuner? Digital tuners are, usually, better than analog tuners. Tuners that have an external F-connector ("co-axial") for an external antenna are almost always better. Again, HD Radio-equipped radios are usually quite good at analog reception, too. You can try Best Buy, or Crutchfield, among others. The Tivoli Model One and Model 10 are also generally good analog tabletop radios.
Any external antenna will be an improvement, but there are degrees here, too. Best is an external VHF antenna on your rooftop (e.g. an old TV antenna on your chimney - see example pic at right) with a rotator. These antennas are high-gain (they boost the desired signal) and directional (reduce the undesired signals) and can be aimed for optimal reception. They're also up higher which means they can better "see over" any hills between you and one of our transmitters.
If you don't already have one of these antennas, you can find them at local electronics stores like A&J Distributor (9 Parade St, Providence, RI / 401-421-0991) or You-Do-It Electronics (40 Franklin St, Needham, MA / 781-449-1005). Ask for a "yagi" (YAH-guhee) FM or VHF antenna (see pic at right). Don't get an antenna that's specifically for UHF - those are only for TV and are more common since the DTV migration of 2009. If you're not sure, look for it to say "VHF." If it does, you're good.
While not necessary, you can also purchase an antenna rotator so you can aim the antenna from the comfort of indoors! You can use the handy website www.FMfool.com to pinpoint the direction to point the antenna, relative to your address.
Engineer's Tip: Got a DirecTV or Dish Network satellite dish, and want to add an FM antenna but don't want to run a second, unsightly coaxial cable? You can "diplex" the satellite TV signal and an FM antenna signal on the same coaxial cable. You'll need a pair of Diplexers such as the "Dual Diplexer Signal Combiner & Splitter" (scroll down a bit, they're $19.99 ea) at either end of the cable.
If an outdoor antenna is impractical, perhaps a Terk Technologies AF-2500 AM/FM+ Indoor AM/FM Antenna may be helpful. We've had reports from fellow public radio stations that this antenna is pretty good...for an indoor antenna (that's a big caveat, though), and has the advantage of being able to be table-mounted or wall-mounted. And it's pretty cheap (about $20-$25) so it's an inexpensive experiment to see if it works in your situation.
Even a simple indoor "di-pole" (DIE-pole) antenna is better than nothing. It's two pieces of wire shaped like a "T", available at Radio Shack and many other electronics outlets. Mount the antenna with the upper part of the "T" is horizontal and is as "broadside" (perpendicular) as possible to the transmitter you're trying to receive.
Listening on a Portable Radio:
In general, listening to us on a portable radio can be tricky. Unlike some of the larger signals in the state, which typically are 50,000 watts...RIPR broadcasts with a 4000 watt signal. We've heard several reports that listening in the Blackstone / East Side neighborhoods in particular have a lot of trouble here. For that neighborhood, the biggest problems are that there's a hill in Rumford behind the neighborhoods and our 88.1FM tower at the Wheeler Farm in Seekonk, and also that WHJY and WBRU, two 50,000 watt stations, are on a tower right next door to the Henderson Bridge; they tend to "swamp" the area with their signals. It also doesn't help that a lot of portable radios just aren't very good receivers. They don't have much filtering, and they rely on the headphone cord to be an antenna, which is electricity inefficient.
There are two solutions you can try:
- There are a handful of portable FM radios that are pretty good receivers, the Insignia NS-HD01 is one of them. It's available at Best Buy for about $40 to $50. We can't guarantee that the Insignia will work for everyone's situation, but it is a good radio so the odds are in your favor.
- Listen to us via a smartphone and 3G/4G connection instead. You can download our iPhone app or listen to us via TuneIn (also works for Android phones). Bear in mind that just like how cellphones can drop calls as you move around, the webcast can also drop out. We've assembled some tips on how to deal with that.
Frequently Asked Questions
Q. Why did Rhode Island Public Radio move to 88.1 FM?
A. 88.1 FM covers a larger broadcast area and it is on the lower end of the FM dial, where listeners expect to find Public Radio. 80% of Rhode Islanders never listen to AM radio. Rhode Island Public Radio will only be financially sustainable if we are completely on the FM band.
Q. What happened to 1290 AM?
A. Rhode Island Public Radio is leasing 1290 AM to Latino Public Radio, Rhode Island's Spanish-language public broadcaster. Latino Public Radio had been on 88.1 FM, but only for part of the day. Our agreement with LPR allows them, for the first time, to broadcast 24 hours a day to their growing audience.
Q. What about 91.5 FM?
A. The 91.5FM signal did not change when we switched from 1290 AM to 88.1 FM.
Q. Why do I sometimes hear music instead of NPR when I tune into 91.5 FM in the afternoon?
A. WCVY is owned by Coventry Public Radio, so they relay RIPR for most of the day. But from 2pm to 8pm on school days, they reserve the right to air programming by their students. On the weekends, school holidays and all summer long, you will hear Rhode Island Public Radio on 91.5 for the entire day.
Q. Why do I hear a sports talk show late at night on Friday/early Saturday morning on 88.1 FM?
A. RIPR leases 88.1 FM from the Wheeler School. As part of our agreement, the school's students can broadcast their own programming on the station. They have produced a sports talk show for this programming block.
Q. What about 102.7FM?
A. In March 2012 we installed a new antenna on 102.7 that improved coverage northward and towards Newport, Portsmouth and parts of East Bay.
Q. When I switch from 88.1 to 91.5FM or 102.7FM, there seems to be a delay of 5 to 10 seconds on 91.5 & 102.7's audio. Why is that?
A. There is an eight second delay on 102.7's audio because it transmits in HD Radio. The nature of the system requires it: HD receivers tune to the analog signal first, buffer the digital signal for a few seconds, then the audio "blends" from analog to digital. Since the digital audio has a coding delay, the analog must also be time-delayed to synchronize it. Currently 91.5 is directly rebroadcasting 102.7 so it's delayed as well.
Q. Why does Rhode Island Public Radio need three signals? Rhode Island is so small, can't we have just one signal that covers the entire state?
A. Rhode Island did not have its own public radio station until 1998. By that time, all of the stations that cover the state were already taken. The radio spectrum in New England is very crowded and there is currently no room to add a new frequency. Purchasing an existing frequency is prohibitively expensive (many, many millions of dollars) so instead, we have worked to build partnerships with other institutions to expand the reach of our signals.
Q. Why did you stop calling the station "WRNI"?
A. After the "Big Switch" in October 2011, Rhode Island Public Radio is now heard on three different frequencies with three different sets of call letters. 88.1, the signal in the most populous part of the state, has the call letters WELH. The others are 91.5 WCVY, and 102.7 WRNI-FM. Because we are now a network of three stations, it makes more sense to call ourselves Rhode Island Public Radio.
Q. I'm still having trouble picking up your signal, even though my area shows as covered on the map.
A. Contact us and describe the issue you are having. Many, many things can impact reception, and our engineer will be happy to discuss your specific setup and any tips that might help.
Q. I just can't seem to get reliable radio reception no matter why I try, are there any options?
A. Yes, we have options for listening online, too: